Broj artikla 44126

fischer Nail anchor FNA II 6 x 25 H with hook

Top Features

Hammerset installation saves time.
No reinforcement hits due to low anchorage depth This saves time and costs during series installation.
Expansion clip provides a firm hold.
With hook.

The installation-friendly Hammerset anchor with hook for multiple fixings.

Advantages

The special active principle allows for a simple hammerset installation and, therefore, a short processing time.
The extremely short anchor depth prevents reinforcement hits, and creates the conditions for a trouble-free installation.
The optimised expansion clip ensures hold when placing in the drill hole, and prevents it falling out during overhead installations.
The massive shaft cross-section guarantees a high load-bearing capacity, thus offering an extremely high level of safety.
A range of head shapes allows for the fixing of wide-ranging fixtures, and for the ideal adaptation to suit the intended use.

The fischer nail anchor FNA II with hook is made of zinc-plated steel. The FNA II is set in a time-saving manner in the pre-positioned installation with just a few taps of the hammer. The installed FNA II expands automatically under load. The cone is then pulled into the expansion clip and expands it against the hole wall. Above all, the fischer nail anchor FNA II with hook is suitable for fixing air lines and hangers in internal areas.

Applications

Fire protection plates
Fire protection boards
Ventilation systems
Wire and Nonius hangers
Mounting rails
Metal clamps
Substructures made of wood and metal

Building materials

Approved for:

Concrete C12/15 to C50/60, cracked, for multiple fixings of non-structural applications

Also suitable for:

Solid sand-lime brick
Natural stone with dense structure
Prestressed hollow-core concrete slabs

Primjenjuju se pojedinosti (građevinski materijali, opterećenja itd.) bilo kojeg dostupnog odobrenja. Dodatne dokumente možete pronaći u Download Center.

Atesti

GS 6.1/21-076-1

Functionality

The FNA II with nail head is suitable for push-through installation. The FNA II M6 is suitable for pre-positioned and push-through installation. The FNA II OE and H are suitable for pre-positioned installation.
The installed FNA II nail anchor expands automatically under load. The cone is pulled into the expansion clip and expands it against the drill hole wall.
Available setting tools:
FNA S-SBO to slip onto the drill,
FNA S-SDS for series installation with a drilling hammer,
FNA S-H for the manual installation of mounting rails.

Mounting Strip 1 Picture

1 / 4

Test report (fire protection)

pdf, GS 6.1/21-076-1

Assessment of the load-bearing behaviour of ﬁscher nail anchors FNA II R and FNA II HCR under tension load and one-sided ﬁre loading according to the ZTV-ING-curve

izdato 05. 10. 2021.

Load Table

pdf,

Nail anchor FNA II - Permissible loads for a single anchor for multiple use of redundant non-structural applications in normal concrete C20/25 up to C50/60.

Anchor length ( l )	54 mm
Drill diameter ( d₀ )	6 mm
Min. drill hole depth for through fixings ( h₂ )	35 mm
Inner diameter of the hook/eye ( d_H )	10 mm
Packaging	Folding box
Amount	50 pcs.
GTIN (EAN-Code)	4006209441268

fischer Nail anchor FNA II 6 x 25 H with hook

Prednosti / opis proizvoda

Upotreba i atesti

Uputstva za montažu

Tehnički podaci

Dokumenti za preuzimanje